This AISI 316 vertical tank level sensor with S3 threaded flange, 0–190 Ω has a nominal length of 28 cm and is intended for level measurement in fuel and water tanks. The sensor is compatible with 12/24 V systems and is mounted vertically from the top of the tank.
The level is detected by a moving, ring-shaped float around the sensor tube. The resistance increases from approximately 0 Ω at the bottom end of the sensor to approximately 190 Ω at the top end, allowing a compatible tank gauge to display changes in the liquid level. The output tolerance is ±(R × 1.5% + 1 Ω).
The sensor is made of AISI 316 stainless steel. The upper housing has a diameter of Ø53.5 mm, the sensor tube measures Ø12.7 mm, and the float measures Ø35 × 32 mm. The nominal sensor length is 280 mm with a permitted deviation of ±5 mm.
Mounting is performed with a BSP 1 1/4" S3 thread. The electrical connection consists of two wires, where black is signal and blue is common. The cable is 460 ±20 mm long. The sensor has an IP65 protection rating, a rated power of 125 mW, and a maximum operating current of 300 mA.
The operating temperature is −40 °C to +85 °C. The sensor family complies with ABYC H-24, USCG 33 CFR 183.590 and ISO 10088, as well as the EMC Directive 2014/30/EU with the relevant EN standards. Instrument compatibility includes Yazaki with three wires, Faria Europa, VDO, Uflex, and Guardian, when the instrument supports the relevant European resistance range.
When mounting on a tank with an international S5 flange, the separate S5-to-S3 mounting flange with item no. 52.746.10 can be used. The sensor and float must be installed so that the float can move freely along the sensor tube.
Key featuresFor fuel and water tanks
Resistance range: 0–190 Ω
Nominal length: 28 cm
12/24 V compatible
AISI 316 stainless steel
BSP 1 1/4" S3 thread mounting
IP65
Cable length: 460 ±20 mm
Operating temperature: −40 °C to +85 °C