This Ankerplex Original demountable stainless steel anchor is model AP8ST with a weight of 8 kg. The patented HHP anchor can be used as a primary anchor, secondary anchor, reserve anchor, or emergency anchor and is recommended for boats of 6.5–7.5 m in general weather conditions and up to 9 m in good weather.
The anchor consists of three flat main parts: shank, fluke, and roll bar. The parts are assembled mechanically without tools and locked with the included fixing shackle. The design has no moving joints or mechanisms that can jam, and the main parts are manufactured by precision cutting without welding or bending. Gloves are recommended during assembly due to edges and angles between the cut parts.
The AP8ST is manufactured from AISI 304 stainless steel with an electropolished, bright finish. Electropolishing provides a resistant surface for use in saline environments. The anchor measures 664 mm in length, 325 mm in maximum width, and 335 mm in maximum height. The material thicknesses are 10 mm at the main plate area and 5 mm at the roll/cross plate, while the anchor area is 541 cm².
The demountable design makes the anchor compact and space-saving for storage. Furthermore, the shape and weight distribution are designed to allow the anchor to release from a bow roller when the chain is deployed. For normal anchoring, sandy bottoms are recommended, while rocks, vegetation, and loose mud should be avoided.
The anchor has two separate holes for attaching the anchor rode. The lower hole is used for general conditions, while the upper hole can be used in soft sand or mud and increases the fluke's penetration angle by approximately 4°. The anchor rode is connected using a separate quality shackle or other suitable connection. When using anchor line, an appropriate chain section must be used near the anchor, at least equal to the boat's length. The recommended minimum scope (ratio of deployed rode to the vertical distance to the bottom) is 1:5 and can be increased to 1:10 during wind, current, or demanding conditions.
For permanent use, the fixing shackle, connection shackle, chain, and other anchor gear should be checked regularly. After occasional use, the anchor should be rinsed with fresh water, dried, and stored in a dry and easily accessible place. The documented storage bag with item no. 01.163.02 fits the AP8ST. The product comes with a 5-year warranty against documented material and manufacturing defects.
Key featuresDemountable HHP anchor, model AP8ST
Weight: 8 kg
AISI 304 stainless steel with electropolished finish
Three flat main parts with tool-free assembly
Included fixing shackle, Ø6 mm
No moving parts, welds, or bends in the main construction
Dimensions: 664 × 325 × 335 mm
Anchor area: 541 cm²
Recommended for boats of 6.5–7.5 m under general conditions
Compatible storage bag: item no. 01.163.02