This Bennett replacement solenoid valve for hydraulic trim tab pump is a 24 V spare part for the port circuit in a Bennett hydraulic trim tab system. This variant features a red wire and manufacturer part number VP1135R24V.
The solenoid valve controls the flow of hydraulic fluid from the Hydraulic Power Unit (HPU) to the trim tab actuator. The red wire identifies the port side circuit, while the system's green valve is used for the starboard side. This variant must be used in a compatible 24 V system and should not be confused with the family's 12 V valves.
The valve is position 9 in the HPU spare parts list and screws directly into the hydraulic unit's valve body. When replacing, the trim tabs must first be fully retracted so that the pressure in the unit is relieved. The wire is released from the connector by holding down the locking barb and pulling the wire out.
During installation, the valve's plunger and spring must remain correctly in place. The valve is screwed hand-tight into the valve body and must not be overtightened. The manufacturer part number is VP1135R24V, and the documented Yamaha OEM cross-reference is 6BT-50079-59-00.
Check system voltage, wire color, operated side, and original part number before purchase. This variant is intended for the port side on a compatible Bennett 24 V hydraulic trim tab system.
Key featuresReplacement solenoid valve for hydraulic trim tab system
24 V variant with red wire
Controls the port side hydraulic circuit
Installs directly into the HPU valve body
Spare part position 9 in the HPU diagram
Manufacturer part number: VP1135R24V
Yamaha OEM cross-reference: 6BT-50079-59-00
Must be installed hand-tight without overtightening
