Electronic tachometer with hour meter for monitoring engine speed from 0 to 8000 RPM. The instrument features a black dial, a polished front bezel, and an integrated hour meter, allowing both current RPM and total engine operating time to be read.
The engine speed is recorded via an RPM signal from the generator's W-terminal. The instrument is designed for 12/24 V DC and has an adjustable signal ratio from 1.0 to 10.0 in increments of 0.1. Calibration is performed using the rubber button on the back, after which the setting is saved automatically after approximately three seconds of inactivity.
The dial can be backlit with either red or yellow light. The 5-pin wiring system includes a blue wire for negative, red for 12/24 V positive, black for the RPM signal, and orange and yellow wires for selecting red or yellow backlighting, respectively.
The instrument has an outer front diameter of Ø96 mm and requires a panel cutout of Ø85 mm. The mounting depth is 55 mm, and there must be at least 55 mm of clearance behind the panel. It can be mounted in panels with a thickness of 0.5–20 mm and is secured from the rear with a fastening ring.
The housing is made of technopolymer, while the polished front bezel is made of AISI 316 stainless steel with a faceted surface. The clear, convex lens has anti-fog properties, and the instrument's ingress protection rating is IP67.
In case of significant signal noise, a series-connected resistor of 1–20 kΩ and ¼–1 W can be used as part of troubleshooting. The resistor is not documented as an included part.
Key featuresMeasuring range: 0–8000 RPM
Integrated hour meter
Voltage: 12/24 V DC
RPM signal from generator W-terminal
Adjustable signal ratio: 1.0–10.0 in increments of 0.1
Selectable red or yellow backlighting
Front diameter: Ø96 mm
Panel cutout: Ø85 mm
Mounting depth: 55 mm
IP rating: IP67