This built-in fuel tank vent in chrome-plated brass with a 90° angle is intended for venting fuel tanks and fuel systems on board. This version is left-facing and features a hose barb for a vent hose with a nominal Ø20 mm connection size.
The angled design directs the hose to the left behind the mounting surface. This makes it possible to adapt the hose routing to the installation conditions. The vent is intended for flush/recessed mounting through the hull, side deck, or another suitable mounting surface.
The vent is made of chrome-plated brass. The top head has an outer diameter of Ø50 mm, while the mounting part measures Ø40 mm. The technical installation geometry includes a vertical dimension of 100 mm and a horizontal protrusion of 68 mm, measured from the centerline of the vertical pipe to the outer end of the hose barb. The neck section measures 18 mm.
Before installation, ensure there is sufficient space behind the mounting location for the left-facing 90° bend and the subsequent hose routing. The hose size must correspond to the nominal Ø20 mm hose connection.
The construction is designed in accordance with the requirements of UNI EN ISO 21487 for permanently installed fuel systems in small craft.
Key featuresBuilt-in vent for fuel tank and fuel system
Left-facing 90° angle
Hose barb for nominal Ø20 mm vent hose
Made of chrome-plated brass
Flush/recessed mounting
Ø50 mm top head and Ø40 mm mounting part
100 mm vertical dimension and 68 mm horizontal protrusion
Designed according to the requirements of UNI EN ISO 21487
