This Lenco replacement actuator for electric trim tabs is a 24 V DC actuator in the 100 Series, model 101 Standard, with manufacturer number 15061-001. It is intended as a replacement part for Lenco Standard Mount, Edge Mount, and Standard Performance trim tab systems.
The electric linear actuator uses a ball screw drive and has a stroke length of 57 mm. The motor has a maximum thrust force of 500 lb, corresponding to approximately 227 kg of load. The hole-to-hole distance between mounting points is 292 mm in the closed position, while the total length is approximately 31.8 cm measured from tip to tip.
The actuator housing is made of high-strength, glass fiber-reinforced nylon, and the cylinder is made of mirror-polished stainless steel. The design is UV-resistant, fully submersible, sealed for life, and maintenance-free. No numerical IP rating is specified.
The actuator has a 5/16″ mounting hole at both the top and bottom, corresponding to approximately 8 mm. It is supplied with a fixed 6 ft, approximately 1.83 m, cable, a waterproof Deutsch Plug & Play connector, and stainless steel mounting hardware. The connector system is designed to protect the connection from water ingress.
The 101 Standard actuator is only component-compatible with controls and switches for the Lenco 100 Series and is not directly compatible with Pro Control/SD Pro systems. The variant is also documented for older Air Boat kits from 2008 and earlier. Check the voltage, manufacturer number, hole distance, and mounting holes on the existing actuator before ordering.
Replaces OEM numbers
OEM no. 20400-101. Documented legacy cross-references include 101-3, 101-4, 10120152, and 10120156. Always compare the cross-reference with the labeling and mounting dimensions on the existing actuator.
Related item numbers
Lower standard mounting bracket: item no. 51.258.11 / Lenco 50014-001D.
Upper bracket for installations up to and including 2007: item no. 51.258.10 / Lenco 50015-001D.
Universal upper bracket for actuators after 2007: item no. 51.258.12 / Lenco 15085-001.
Standard hardware kit: Lenco 10250-401D.
Universal hardware kit for 100 Series: Lenco 10250-410D.
14 ft extension cable: item no. 51.259.02 / Lenco 30133-002D.
20 ft extension cable: item no. 51.259.03 / Lenco 30133-103D.
The 100 Series actuator is covered by a 5-year manufacturer's warranty in accordance with the applicable warranty terms.
Key features24 V DC replacement actuator
101 Standard in Lenco 100 Series
Manufacturer number 15061-001
57 mm stroke length
292 mm closed hole distance
5/16″ mounting hole at top and bottom
Max. thrust force of 500 lb, approximately 227 kg
Glass fiber-reinforced nylon and mirror-polished stainless steel
UV-resistant, fully submersible, and maintenance-free
1.83 m cable with waterproof Deutsch connector
