Solas Amita 3 aluminum propeller for Yamaha/Selva/Parsun, 7 splines is a 3-blade aftermarket propeller with a diameter of 8.5" and a pitch of 9". This right-hand rotation variant has manufacturer number 3011-085-09 and is intended for documented Yamaha, Selva, and Parsun outboard motors with a 7-tooth propeller shaft.
The propeller is manufactured from aluminum using a squeeze cast process, which provides a stronger and less porous material than traditional die-cast aluminum. The Amita 3 series' three-blade design is developed with a focus on acceleration and top speed.
A traditional, pressed-in rubber hub is integrated into the propeller, meaning no separate Rubex hub kit is required. Exhaust is routed through the propeller hub, and the propeller is mounted via spline drive on a 7-tooth propeller shaft.
The surface is protected with four layers of coating. The aluminum propellers in this series have been tested for more than 500 hours in salt fog/salt spray to verify corrosion protection under maritime conditions.
Compatible engine models
Yamaha: 6 hp 2-stroke from 1986-2000, F6 4-stroke from 2001-2010, 8 hp 2-stroke from 1986-2009, F8 4-stroke from 2001 and F9.9 4-stroke from 2008.
Selva: Ray 8 hp 4-stroke and Pike 9.9 hp 4-stroke.
Parsun: F6 4-stroke and F9.8 4-stroke.
All engines must have the documented 7-spline configuration as well as the correct gear case, rotation direction, and clearance.
OEM cross-references
The propeller cross-references to Yamaha OEM no. 6G1-45941-00-EL and 6G1-45941-00-00. The cross-reference is a replacement match; the specified pitch of the Yamaha original propeller is not identical to this variant's pitch of 9".
When mounting, the engine's original propeller nut, washers, spacers, and cotter pin must be checked and installed according to the engine manual. Check the clearance to the gear case and trim tab, and check after a test run that the engine's RPM at full throttle is within the engine manufacturer's recommended range. The correct pitch also depends on the boat, load, and operating conditions.
Always check the engine/drive model and original part number before purchasing.
Key featuresAmita 3 aluminum propeller with 3 blades
Diameter and pitch: 8.5" x 9"
Right-hand rotation (standard)
7 splines
Through-hub exhaust
Pressed-in rubber hub
Squeeze cast aluminum
Four layers of anti-corrosion coating
Manufacturer number: 3011-085-09
