Universal electronic tachometer with hour meter for marine engine installations. This variant has a measuring range of 0–3000 RPM, a white dial, a polished bezel, and integrated engine hour tracking. The instrument connects to the generator's W-terminal and can be powered directly by 12 or 24 V DC.
The backlit dial can be illuminated with either red or yellow light. The light color is selected via the relevant wire in the five-pin connector: orange wire for red illumination and yellow wire for yellow illumination. The other connections are blue for negative, red for positive supply, and black for the RPM signal.
The instrument has an external front diameter of 96 mm and is mounted in an Ø 85 mm panel cutout. It can be installed in panels with a thickness of 0.5–20 mm and requires at least 55 mm of clearance behind the panel. The instrument is inserted through the panel hole and secured from behind with a fastening ring.
The housing is made of technopolymer, while the polished front bezel is made of AISI 316 stainless steel. The convex, transparent lens is anti-fog treated, and the instrument has an IP67 protection rating. The rear connection is made via a plug-in connector.
Calibration is performed using the rubber button on the back of the instrument. The signal ratio can be adjusted from 1 to 10 in steps of 0.1 and must be set according to the engine's actual RPM and signal data. The setting mode is activated by holding the button for approximately three seconds, and the selected value is saved automatically after approximately three seconds of inactivity.
If strong interference in the RPM signal prevents the needle from tracking the engine speed correctly, a 1–20 kΩ series resistor with a power rating of 1/4–1 W can be used during installation. Alternatively, a 20 kΩ potentiometer can be used for testing and adjustment.
Key featuresMeasuring range: 0–3000 RPM
Integrated hour meter for tracking operating hours
For 12/24 V DC installations
Signal connection to generator W-terminal
Choice of red and yellow backlighting
External front diameter: 96 mm
Panel cutout: Ø 85 mm
Mounting depth: 55 mm
Polished AISI 316 stainless steel bezel
Anti-fog treated convex lens and IP67 protection rating