Veratron VDO rudder angle sensor for single helm station

Mærke: VDO Marine SKU: 27.176.00

Price:
Sale price1.075,00 kr

Description

This Veratron VDO rudder angle sensor detects the mechanical position of the rudder and transmits an analog sensor signal to a compatible rudder angle instrument. This variant is intended for single-station use and is employed in marine rudder angle indicator systems with 12/24 V.

The sensor is compatible with instruments in the VDO Ocean and ViewLine series and can be used with the white ViewLine rudder angle indicator, item no. 27.495.01, or the black variant, item no. 27.595.01. A complete system also requires the documented 8-pin cable with connector, item no. 27.599.11.

The adjustable sensor arm allows for the mechanical connection to the steering system to be adapted. When mounting on a hydraulic rudder segment, the length of the sensor arm must correspond to the rotation radius of the rudder segment if the instrument is to display the actual rudder angle analogously. With the rudder in the center position, the balance arm must be positioned at 90° ±15° relative to the sensor arm.

For cable or wire steering, the sensor is mounted so that the steering cable passes close to the sensor shaft within the rotation range of the sensor arm. The length of the sensor arm is adapted to the travel of the cable, and the zero position is set at a 90° angle to the steering cable when the rudder is in the center position. The sensor arm and mechanical connections must be able to move freely throughout the entire steering range. The balance arm and connecting link are not included.

The sensor housing is oil-filled and must not be opened. The sensor's measuring lead must not be shortened. Before electrical installation, the battery's negative terminal must be disconnected, and the cables must be protected against pulling, pressure, sharp edges, moving parts, and parallel routing with ignition cables or large power consumers.

After installation, check the instrument reading at full port, center, and full starboard. The position and orientation of the sensor can then be fine-tuned mechanically so that the center position of the instrument corresponds to the actual center position of the rudder. The sensor is intended for pleasure craft and non-classified commercial shipping.

Key features

Rudder angle sensor for single-station use
For analog marine rudder angle indicator systems
System voltage: 12/24 V
Compatible with VDO Ocean and ViewLine instrument series
Adjustable sensor arm
Can be mounted with hydraulic rudder segment or cable/wire steering
Oil-filled sensor housing which must not be opened
Balance arm and connecting link are not included

Did you know?

... that many of our products can be ordered online and picked up in our self-service stores?

See more here: Self-service stores

Did you know

... that many of our items can be ordered online and picked up in our self-service stores?

See more here: Self-service stores

Alpina Marineudstyr

Ask us about the product

Send us your question. The product will automatically be included in your message.

Veratron VDO rudder angle sensor for single helm station
Veratron VDO rudder angle sensor for single helm station Item no. 27.176.00

Description

Produkt: Rorvinkelsensor
Mærke: Veratron VDO
Produkttype: Analog rorpositionssensor til marineinstrument
Anvendelse: Registrering af rorets mekaniske position
Volt: 12/24 V
Stationstype: Én styreplads
Signaltype: Analogt sensorsignal
Sensorhus: Oliefyldt
Sensorarm: Justerbar
Montering: Hydraulisk rorsegment eller kabel-/wirestyring
Kompatibilitet: VDO Ocean- og ViewLine-instrumentserier samt rorvinkelindikator 27.495.01 og 27.595.01
Nødvendigt kabel: 8-polet kabel med stik, varenr. 27.599.11
Medfølger ikke: Balancearm og forbindelsesstykke

Similar products

Recently viewed products