Veratron VDO ViewLine fuel gauge is an analog 52 mm panel instrument for displaying fuel level from empty to full. This black variant is intended for a resistive tank sender with 240 Ω at empty tank and approximately 33–33.5 Ω at full tank and can be used in both 12 and 24 V DC systems.
The fuel level is displayed on a black, backlit E–F scale with a white pointer and 90° pointer deflection. The dial illumination is amber, while the pointer and the integrated warning indicator use red LED light. The instrument has a proven accuracy of ±3.6 angular degrees and a current consumption of less than 140 mA including the warning LED.
The housing is made of polycarbonate and has a double PMMA lens with anti-fog function. The front is IP67-protected, while the back is classified IP52. The instrument can withstand operation and storage from −30 to +80 °C with the black plastic bezel and features protection against polarity reversal and overvoltage.
For standard front mounting, a panel hole of Ø53 mm and a panel thickness of 0.5–20 mm are required. The instrument housing has a nominal diameter of 52 mm and an installation depth of 50 mm; there must be at least 65 mm of free space behind the panel. Fastening is done with a central Spinlock nut. Flush mounting from behind is also possible in a Ø48.1 mm panel hole with 1.5–3 mm panel thickness, but requires a separate gasket and mounting bracket.
The electrical connection is made via an 8-pin Tyco/Hirschmann MQS connector with separate connections for ignition plus, ground, permanent battery supply, sender ground, sender signal, instrument illumination, and warning LED. The pre-wired 8-pin cable with part no. 27.599.11 is used for the connection. The installation wiring diagram requires a 5 A fast-blow fuse, and the instrument must be placed at least 500 mm from a magnetic compass.
The instrument must be combined with a fuel sender that follows the 240–33.5 Ω curve. Compatible sender principles include arm/float senders, including A2C59510172 without low-level switch and A2C59510166 with low-level switch. The adjustable arm sender with part no. 27.160.05 has the same 240–33 Ω signal and is intended for tanks with a height of approximately 150–600 mm. Always check the sender's resistance range and tank dimensions before installation.
Installation should be performed by a professional with the negative terminal of the battery disconnected. The rear side must be mounted in a suitably protected panel environment, and the instrument should only be cleaned with clean water.
Key featuresAnalog E–F fuel level display
For resistive sender with 240 Ω at empty and 33–33.5 Ω at full tank
12/24 V DC
Nominal instrument diameter: 52 mm
Panel hole for front mounting: Ø53 mm
Installation depth: 50 mm
IP67 front and IP52 rear
Amber dial illumination and red pointer illumination
Integrated red warning LED
8-pin Tyco/Hirschmann MQS connection