This Whale Supersub Smart automatic submersible bilge pump is a low-profile 12 V electric centrifugal pump designed for rapid removal of standard bilge water. Model 650 has a capacity of 650 US GPH and delivers 40 l/min at 0 m and 34 l/min at 1 m head.
The integrated electronic field and water level sensor starts and stops the pump automatically, eliminating the need for a separate float or bilge switch. The sensor features solid-state switching with no moving parts and a 5-second start delay to prevent unnecessary activation caused by wave motion. The pump can also be operated manually via the three-wire connection.
The low, narrow design measures 212 × 54 × 75 mm and is intended for tight and shallow bilges, such as under cockpit floors or engines. The pump housing and discharge can be rotated to adapt the installation to the available space. An integrated air vent prevents airlocks, while the non-return valve limits backflow. Depending on the installation, the bilge can be drained to a water level of approximately 9 mm.
The stepped discharge port fits 19 mm (3/4") or 25 mm (1") hose. The pump has a power consumption of 3.4 A, requires a recommended 5 A automotive fuse, and should be connected using 1.5 mm² or 16 AWG wire. The maximum recommended head is 3 m.
The pump housing is made of polypropylene and high-temperature ABS, while the impeller is made of glass-fiber reinforced PBT. The electronics are fully potted, and the pump is suitable for both fresh and salt water. The sensor is designed for stable operation in the presence of dirt, oil, or fuel residue in the bilge, although the pump is intended for standard bilge water.
During installation, the discharge must be routed to a properly installed thru-hull fitting above the waterline, and the discharge system must be protected against siphoning. The pump may be mounted at an angle of up to approximately 30° and must be secured to a bulkhead or mounting board, not directly to the hull. The strainer and impeller should be checked regularly and cleaned with warm soapy water. The pump is not designed for internal servicing and must be replaced as a complete unit in the event of failure.
The pump is CE-certified and NMMA Type Certified, and meets ISO 8849, ISO 15083, ISO 8846, ISO 10133, and ABYC H-22 standards.
Key featuresAutomatic submersible 12 V low-profile bilge pump
Capacity: 650 US GPH
Flow: 40 l/min at 0 m and 34 l/min at 1 m
Integrated electronic water level sensor with manual override
Power consumption: 3.4 A
Stepped discharge port for 19 or 25 mm hose
Rotatable pump housing and discharge
Integrated air vent and non-return valve
Suitable for fresh and salt water
Manufacturer part number: SS5212