This Whale grey waste tank lid with 1 IC sensor is a replacement lid and service kit for the automatic control of the onboard grey waste pump. The integrated electronic Intelligent Control sensor detects liquid at a pre-set level, starts the pump, and turns it off again once the tank is empty.
The sensor operates on a solid-state principle without mechanical floats or other moving sensor parts that can get stuck. The lid's splash-proof triple seal separates the electronics from the grey waste. The construction includes glass-reinforced polypropylene, ABS, and polyurethane, along with seals in EPDM/neoprene and Monprene®.
The service kit is intended for 12 or 24 V DC and can control a compatible grey waste pump with a power consumption of up to 20 A without a separate relay. The AK1005 variant has tinned wire ends and should not be confused with versions featuring Deutsch connectors or two sensors.
The lid is compatible with Whale GT0810B, GT1610B, and GT2010B grey waste tanks as well as the complete tank variants with item no. 16.222.94 and 16.222.98. It can be used with Whale Gulper 220 and Gulper 320 pumps when the pump's power consumption does not exceed 20 A. The product is a replacement lid with a sensor and does not include a tank or pump.
The kit consists of a lid, an electric field sensor with tinned wire ends, a cable gland, two support rods, four screws, and four washers. During installation, the power must be disconnected, the grey waste system emptied, and the circuit protected with an appropriate fuse or circuit breaker. Operation should be verified after installation by filling the tank and ensuring the pump starts and empties the system automatically.
The sensor surfaces on the underside of the lid should be cleaned of dirt and soap residue at least every three months without using abrasive cleaners. The yellow electronics cover must not be removed, and the unit is not intended for repair. The system should be drained before frost, and piping as well as fittings should be inspected regularly for blockages and leaks.
Key featuresReplacement lid with 1 integrated IC sensor
Automatic start and stop of the grey waste pump
Solid-state sensor without moving parts
For 12 or 24 V DC
Controls pumps up to 20 A without a separate relay
Tinned wire ends
Splash-proof triple seal
Compatible with Whale GT0810B, GT1610B, and GT2010B
Can be used with Whale Gulper 220 and Gulper 320
Manufacturer part number AK1005