This Whale Watermaster automatic pressure pump is an electric four-chamber diaphragm pump for pressurized water supply systems in leisure boats. The FW1215 bulk variant delivers an open flow of 11.5 l/min at 12 V DC and is sized for systems with up to four taps or other outlets.
The integrated automatic pressure switch starts the pump when a tap or shower is opened and stops it again at a cut-off pressure of 3 bar. Four diaphragm chambers contribute to a smooth flow and a lower noise level. The pump is self-priming up to 3 m, has a maximum delivery head of 30 m, and can run dry for short periods without immediate damage. It is not intended for continuous operation and has a maximum duty cycle of less than 33%.
The motor is protected by a fully sealed IP65-rated housing. The pump housing is made of glass-reinforced polypropylene, while the diaphragm, valves, and feet are made of Monprene®. The seals are made of nitrile, and the fasteners are made of stainless steel. The pump can be used for both fresh water and salt water, but not for flammable liquids, diesel, or chemicals.
The inlet and outlet feature 15 mm Whale Quick Connect female fittings, and an inlet strainer is included. The free internal pipe diameter of the system should be at least 10 mm to avoid reduced flow. A fitting with a 1/2" BSP male thread, item no. 17.815.87, can be used as an alternative connection option.
The pump must be installed in a dry, ventilated, and accessible location for service and must be placed no more than 3 m above the water tank. It can be mounted horizontally or vertically, preferably with the pump head below the level of the motor. The adjustable mounting feet are secured with three stainless steel screws and washers to a bulkhead at least 19 mm thick or a separate mounting plate. The pump must not be screwed directly into the boat's hull.
The electrical installation is carried out with at least 1.5 mm² cable, an isolation switch on the positive conductor, and a recommended 7.5 A blade fuse. The red wire is positive, the black is negative, and the third white wire can be connected to an indicator light that shows when the pump is operating. Wire connections below the maximum bilge water level must be made as waterproof IP65 connections. The pump is also functionally relevant for pressurized water systems in motorhomes and caravans.
Service and accessories
Documented service components include pump head AK1316, microswitch kit AK1317, and inlet strainer AK1319. The inlet strainer is also available as item no. 16.700.19. The Aquasource filter WF1530 can be used as an additional water treatment filter in a compatible 15 mm system.
Key features12 V DC automatic diaphragm pressure pump
Open flow: 11.5 l/min
Cut-off pressure: 3 bar
Four diaphragm chambers with automatic pressure switch
For systems with up to four outlets
Self-priming up to 3 m
Maximum delivery head: 30 m
15 mm Whale Quick Connect female fittings
IP65-sealed motor housing
Inlet strainer included